Bottom painting - what not to paint
Moderators: BeaconMarineBob, Moderator, BeaconMarineDon
Bottom painting - what not to paint
I think I have this right but just wanted to be sure. Paint the rudder and the shaft plate (where the shaft comes throught the hull), and the shaft bearing. Leave the Shaft, prop, zincs, transducers, trim tabs, and swim platform supports unpainted. Is this right?
Thanks,
Neal
Thanks,
Neal
- prowlersfish
- 2025 Gold Support
- Posts: 12724
- Joined: Sat Nov 05, 2005 6:56 pm
- Location: Lower Chesapeake Bay ,Va
other then the zincs I paint it , as of late I have been using pettit prop-koat on the shafts and props It work better then paint another very good product fot ther props / shafts is prop speed . on the transducer use a trans ducerpaint as the reg paint can damage them . I have used a water base bottom paint on then instead with good luck but thats at your own risk
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat

I paint everything but the zincs and props. I tried an experiment two seasons ago when I replaced my trim tabs--I didn't paint them. I can't begin to describe the fauna that sprouted up. After much scraping, last season's paint job eliminated the problem. And my boat rarely sits for more than a couple of days at a time from April to November.
Brett
Brett
- Stripermann2
- Ultimate User
- Posts: 3027
- Joined: Fri Jan 19, 2007 9:11 am
- Location: Solomon's Island, MD
I have lil' fishies painted all over the bottom of my boat...
I need all the help I can get out there!

I need all the help I can get out there!

Jamie
1985 F-32 270 Crusaders
1988 Sea Ray 23 350 Merc.
Trojan. Enjoy the ride...
-I don't wanna hear anyone whine...Anymore!
-You might get there before me, but you still have to wait for me, for the fun to start!
1985 F-32 270 Crusaders
1988 Sea Ray 23 350 Merc.
Trojan. Enjoy the ride...
-I don't wanna hear anyone whine...Anymore!
-You might get there before me, but you still have to wait for me, for the fun to start!
I was told by the guy at my marine suppy store not to paint the shaft because the copper in the shaft will react with the shaft material. Also it looks like the previous owner did not paint the trim tabs or the swim platform supports(i'm guessing for the same reason). Is there any truth to this?
Neal
Neal
- prowlersfish
- 2025 Gold Support
- Posts: 12724
- Joined: Sat Nov 05, 2005 6:56 pm
- Location: Lower Chesapeake Bay ,Va
- prowlersfish
- 2025 Gold Support
- Posts: 12724
- Joined: Sat Nov 05, 2005 6:56 pm
- Location: Lower Chesapeake Bay ,Va
- guglielmo6160
- Moderate User
- Posts: 782
- Joined: Mon Nov 10, 2008 10:07 pm
- Location: cape coral florida
- prowlersfish
- 2025 Gold Support
- Posts: 12724
- Joined: Sat Nov 05, 2005 6:56 pm
- Location: Lower Chesapeake Bay ,Va