Outrigger poles

rap55 · Post by **rap55** » Sun Mar 13, 2011 4:01 pm

Anybody run into secondhand outrigger poles that will fit the Lee junior holders I got from Bob...Let me know.

Thanks, Rick - F-36 / MissKitty

prowlersfish · Post by **prowlersfish** » Sun Mar 13, 2011 7:25 pm

What is the inside ID of the holders ?

rap55 · Post by **rap55** » Sun Mar 13, 2011 9:21 pm

Think they are Lee Juniors with 1-7/8 inch inside to inside the Holders.

Thanks , Rick

prowlersfish · Post by **prowlersfish** » Sun Mar 13, 2011 9:42 pm

Do you think or do you know thats the ID ? better be sure ass this can be costly $$$$$$ been down that road on other things

rap55 · Post by **rap55** » Sun Mar 13, 2011 10:00 pm

Well...I caint be 100% sure because the boat and holders are in Pensacola and I caint get back down there until next week. But...My buddy in P-cola went out to the dock and measured and thats what he came up with. He say`s they are 1-7/8 inside to inside.

Thanks, Rick

prowlersfish · Post by **prowlersfish** » Sun Mar 13, 2011 10:18 pm

Perko makes a 1.9" pole 1 7/8 is 1.875 a .025 difference real close . I hope there perko as the can save you some $$$$ on the poles ( lees are out of sight ) a inside mic. or caliper would be nice

http://www.foreandaftmarine.com/9-1798015ALU.htm

http://www.foreandaftmarine.com/Outriggers.htm

rossjo · Post by **rossjo** » Sun Mar 13, 2011 10:39 pm

Try to get a short enough length to fit under your local bridges. Putting them up/down or waiting for the draw or swinging bridge are a real pain.

Good luck - try a country wide Craigslist Search!

Struts and Rudders · Post by **Struts and Rudders** » Wed Mar 16, 2011 9:13 am

We have removed the outriggers from my boat.
I have no use for them.
They are the triple spreader type...in fair condition.
I have the entire system...mounts poles etc

rossjo · Post by **rossjo** » Wed Mar 16, 2011 9:20 am