Tri cabin owners please help me

Tri-Guy · Post by **Tri-Guy** » Thu Apr 28, 2011 7:52 pm

I have a 1980 Tri Cabin with the engines under the salon.My problem is how is the rug cut in around the hatches.The way the hatches overlay each other is a problem.Any pictures or comments would be great. thanks.

k9th · Post by **k9th** » Fri Apr 29, 2011 5:58 am

I have posted one photo of the salon in our tri-cabin that was taken when I first bought the boat. We have a runner down the center so the seams are a little hard to see but they match up perfectly as this one shows in front of the cabinets.

Tri-Guy · Post by **Tri-Guy** » Fri Apr 29, 2011 6:29 am

Thanks Tim how are the edges of the hatches done,yours looks good how is each hatch done.Thanks John

k9th · Post by **k9th** » Fri Apr 29, 2011 8:35 am

Here is a quick sketch I just made here at work that shows how my engine covers are constructed and what the joint looks like. They fit very snugly into place and there are four total covers - two narrower ones down the center that allow me to check oil and all items in the engine room and two larger ones over each engine that give full access to the engines and the entire area. I have a D-ring type of pull up opener in the front center one to get the first one out.

I may be at the marina this weekend and if you want I can get more photos that specifically address what you are needing.

Hope this helps.

Tri-Guy · Post by **Tri-Guy** » Fri Apr 29, 2011 4:51 pm

Thanks Tim my hatches are exactly the same as yours.I would really appciate some detailed pics of yours.The carpet on my boat is one piece that I have to pull back,previous owner not me.I need to figure this one out soon.Thanks John

aaronbocknek · Post by **aaronbocknek** » Sat May 07, 2011 10:42 am

i have the same layout. the previous owners had the boat recarpeted in 2005 and the carpet edges are tucked under at the hatch edges. if you want, i can take a few pics and email them to you to give you an idea.
aaron in baltimore.

k9th · Post by **k9th** » Sat May 07, 2011 7:50 pm

John -

Just returned from the boat yard and got three photos. Hope they help.

Two center access panels

Access panel side closeup

Access panel opening in floor

Please excuse the dirt - I am in the process of cleaning before launch. I am putting it in the water next Friday - the 13th. Hope that's not a bad omen.

Tri-Guy · Post by **Tri-Guy** » Sat May 07, 2011 10:07 pm

Thanks Tim those pictures are what I needed.From the pics it looks like the carpet is cut out around each hatch not wrapped. Thanks John

k9th · Post by **k9th** » Sun May 08, 2011 8:13 am

That's the way mine is. It sounds like Aaron's might be different and I think he will get photos of his also if you want.

Aaron is a wealth of knowledge about tri-cabins since his dad bought one in the early 70's and he grew up on one. He is a walking encyclopedia about tri-cabins and Trojans in general and he loves helping so don't be afraid to ask him anything. He works as a flight attendant and is not always on the forum on a daily basis but he will get back to you.