Jefflaw35

jefflaw35 · Post by **jefflaw35** » Sat Feb 11, 2012 7:58 pm

Me to, just had a busy cold day, just settling down now and ready for some info, is it fabricated? If so can I have specs and material type so I can make some? Or what did it come off of?

Paul · Post by **Paul** » Sat Feb 11, 2012 9:16 pm

I bought it new here in Windsor but it but I believe it was manufactured in
Michigan. I'll get some more info in it and post it.

jefflaw35 · Post by **jefflaw35** » Sat Feb 11, 2012 11:18 pm

Thanks Paul, I'm tossing around everyone's suggestions, but if it helps me to have both to decide on my own then I'm good. I can change rudder and prop while in the water so it's not a problem to us. I would like to feel both side for myself

Paul · Post by **Paul** » Thu Feb 16, 2012 8:52 pm

The rudder came from Marine Machining & MFG in Clinton Twp. Michigan. (586) 791-8800.

foofer b · Post by **foofer b** » Thu Feb 16, 2012 9:00 pm

Paul · Post by **Paul** » Thu Feb 16, 2012 9:18 pm

Paul wrote:The rudder came from Marine Machining & MFG in Clinton Twp. Michigan. (586) 791-8800.

Here's the link

http://www.marinemachining.com

jefflaw35 · Post by **jefflaw35** » Thu Feb 16, 2012 9:20 pm

Thanks Paul I appreciate it!!!

Torcan · Post by **Torcan** » Fri Feb 17, 2012 3:18 am

Thanks Paul
going to look into it