Fogging engine

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
fourreins
Moderate User
Posts: 216
Joined: Mon Aug 24, 2009 6:10 pm

Fogging engine

Post by fourreins »

Unfortunately it is that time of year and I had winterize my two Crusader 454's yesterday. The boat has a closed system so the process is very simple. I had one question around fogging I was hoping someone could answer. During the process of sucking the pink stuff through the system I was fogging the engine. I sprayed quite a good bit of fogging oil down the carb but never really got any smoke out the back. In fact the engine really didn't bog down at all. Each engine had the same response to the fogging oil. Don't you usually see a lot of smoke?
User avatar
Big D
Ultimate User
Posts: 2876
Joined: Sat May 01, 2010 10:39 pm
Location: Ontario, Canada

Post by Big D »

Some folks won't like this comment but personally, I wouldn't worry about it. IMO, people stress too much about fogging. I don't feel it's that big a deal for the amount of time we are layed up given today's oils and the metallurgy strides of the last 50 years. If you feel the need to do it now, spray some down the carb while cranking the engine with the ignition grounded. This will prevent the engine from firing while ingesting the oil droplets to coat the cylinders. If it has to be done, running the engine IMO is not the way to do it given that you burn most of it which kind of defeats the purpose. While some will say pull the plugs and pour in some oil, you need to be cafefull with this method and also keep in mind that in a V engine, you will only coat the lower section of the cylinder, spray is better, then turn over the engine a couple of times. I wouldn't lose any sleep over it but that's just me!
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
User avatar
Landlocked
Registered user
Posts: 69
Joined: Wed May 23, 2012 6:26 pm
Location: Independence, KS

Post by Landlocked »

I fog my 454 Crusaders every year (for the past 22 years) by trickling some Marvel Mystery oil down the throat of the carb as I'm shutting it down for the last time. My engine will complain a little as I'm trickling, but I never give it enough to kill it. I usually don't see smoke on shut down, but it will smoke for a short while on the spring start up.

Probably the wrong way to do it. Probably potentially harmful if I let too much pour in at once - but it seems to work.
Lake boaters skip the salt...
1985 11 Meter Sedan
1972 Newman Bassboat
1990 Cyclone Jetboat
1957 Fiberglass Barracuda (Olds 425 cubic Inch, Edelbrock)
User avatar
Commissionpoint
Active User
Posts: 1197
Joined: Wed Oct 05, 2011 11:59 pm
Location: Diamond Point on Lake George, NY

Post by Commissionpoint »

Landlocked wrote:I fog my 454 Crusaders every year (for the past 22 years) by trickling some Marvel Mystery oil down the throat of the carb as I'm shutting it down for the last time. My engine will complain a little as I'm trickling, but I never give it enough to kill it. I usually don't see smoke on shut down, but it will smoke for a short while on the spring start up.

Probably the wrong way to do it. Probably potentially harmful if I let too much pour in at once - but it seems to work.
Roger that Landlocked. Thats how I have been doing it since I got my first carbbed I/O when I was 14. I learned to do it that way from watching my dads Trojan and Chris Crafts being winterized as a kid, and see no reason to change my ways either.

That being said I got a helluva deal on storage and winterizing of all systems from the yacht club and they will have me back in early April. My haul date is 11/2. So it looks like I'll have a 5 month layup. It comes to just under 300 bux a month including winterizing and recommissioning. I'll surely be watching to see if the proceedure used today has evolved or stayed relatively the same in the last 30 years.
1978 F-32 "Eclipse"
Merc 305 SBC's
1.52:1 Borg Warners

1983 Correct Craft
Commander 351 Ford (PCM)
1:1 Borg Warner

There are 350 different varieties of shark, not counting loan or pool.
User avatar
Mike Kulp
Moderate User
Posts: 234
Joined: Mon May 16, 2011 4:53 pm
Location: Upper Chesapeake Bay/Middle River
Contact:

Post by Mike Kulp »

I have to agree with Big D hat it probably doesn't matter if you fog or not but I do fog every year and have always done it, I use two cans at the same time until the motor is barely running then have my wife shut off the engines. i used two pull the plugs on my other boat and spray the cylinders until one time the red straw came off and shot into the cylinder, took me hours to retrieve it, that was it for pulling the plugs.
Mike 1986 10 Meter mid cabin
User avatar
prowlersfish
2025 Gold Support
2025 Gold Support
Posts: 12725
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Post by prowlersfish »

If you turn the engine over once in a while , that would do more good then fogging IMO .
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
User avatar
Big D
Ultimate User
Posts: 2876
Joined: Sat May 01, 2010 10:39 pm
Location: Ontario, Canada

Post by Big D »

prowlersfish wrote:If you turn the engine over once in a while , that would do more good then fogging IMO .
BINGO! Exactly what I do about once every week or two. Also for the same reason that I don't like all the hardware sitting in the same position for so long; including the impellers that I'm just too lazy to remove for the winter. Don't get me wrong, fogging has it's place, but for the amount of time the average boat is laid up for winter, no need IMO.
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
User avatar
Paul
Active User
Posts: 1141
Joined: Fri Jun 10, 2005 1:02 pm
Location: Windsor Ont.

Post by Paul »

Fogging procedure:

- remove flame arrestor
- bring engine up to operating temp
- at idle, spray fogging oil (without tube) into front two barrels of carb until light smoke appears from exhaust
- turn off engine
- clean & replace flame arrestor
- pour glass of cognac
- light Cuban cigar
- toast the end of a good season

This procedure works well for me every season.
8)

PS The engine is usually running on a -37°F mix of Prestone while fogging.
Paul
"Cruise Control" 1978 F-26HT
"No Control" 2012 9' Grand RIB
larryeddington
Ultimate User
Posts: 1876
Joined: Mon Sep 28, 2009 5:08 pm
Location: Canton, TX Boat on TEXOMA

Post by larryeddington »

Like Paul's Idea, If you have twins I guess you are entitled to two drinks and two Cubans or facsimile/ :lol:
Last edited by larryeddington on Wed Oct 10, 2012 9:27 am, edited 1 time in total.
Larry Eddington
1984 F-36 Tri Cabin "The Phoenix II"
1978 F-28 "The Phoenix"
Fish Master 2350 Bay Boat
9.5' Dink
Allen Sr
Active User
Posts: 1159
Joined: Fri Oct 15, 2010 6:37 am
Location: Baltimore,Md.

Post by Allen Sr »

larryeddington wrote:Like Paul's Idea, If you have twins I gues you are entitled to two drinks and two Cubans or facsimile/ :lol:
I would say so or the other engine could feel like a redheaded step child and really act up next season! :wink: :lol: :lol: :lol:
Growing old is inevitable,but growing up is optional
1984 F36 w/350 Crusaders 'Reel Class'
2011 Trojan Rendevous
Solomons Get Together 2011
Ocean City 2012,2013,2015
Post Reply