Engine rattle

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
User avatar
Diverted Income
Moderate User
Posts: 309
Joined: Wed Nov 28, 2012 8:18 pm
Location: N.E. Iowa

Engine rattle

Post by Diverted Income »

I have an intermittent rattle on my STBD engine. Sounds like it is coming from the bellhousing area but tough to tell for sure. Always sounds the same and not constant. In gear or out. Do these have a flex plate or a flywheel on the crank? (82 Merc MIE 230HP GM 305 straight Velvet Drive) Rattle has not gotten worse or changed at all. Sounds a little tinny and certainly not in oil.

Next question: Is there any adjusting the sliding screen door rollers on an 82 F-32?

Thanks!
1982 Trojan F-32 w/Merc 230's
1975 Baja V-1800J w/ 502 Ford
http://missriverrat.com
https://www.facebook.com/UMRMriverrat
User avatar
BobCT
Active User
Posts: 1068
Joined: Mon Sep 07, 2009 9:01 pm
Location: New Haven CT

Re: Engine rattle

Post by BobCT »

Yes, could definitely be the flex plate. How low is the idle set? And, please keep in mind a misfire or dead cylinder will sound exactly the same. There are some legendary posts about flex plate noises being mis diagnosed so rule that out first. I had the exact same noise when my boat was surveyed. Surveyor said flex plate and it turned out to be a burned cap/wire.

Bob
1988 10m mid cabin
Post Reply