deadrise

MUSICMAN7775 · Post by **MUSICMAN7775** » Sat Mar 08, 2014 1:30 pm

Would anyone happen to know the dead rise of an F-32 and
is it tuff to remove the old transducers from the bottom so new transducers can be installed?

comodave · Post by **comodave** » Sat Mar 08, 2014 8:42 pm

My survey states 8 degrees at the transom. The surveyor was a previous F32 owner and appeared to be very knowledgeable about the F32's.

larryeddington · Post by **larryeddington** » Sun Mar 09, 2014 4:27 pm

don't know about f32 specific but my f28 is way different angle of deadrise transom verse mid boat. Maybe I do not understand where dead rise is measured but to mount a transducer the angle cut on adapter would be very different locations, and one would not want a transducer behind the turbulence caused by the screws. IMO

Stripermann2 · Post by **Stripermann2** » Mon Mar 10, 2014 10:00 am

5 degrees from my spec sheet.

MUSICMAN7775 · Post by **MUSICMAN7775** » Tue Mar 18, 2014 11:11 pm

Thanks for all the info. Now I need to find out who made the factor installed transducers
and paddlewheels. I want to replace them and use the original holes for the new transducers.
Don't know size the holes are.

Trojan Boat Forum

deadrise

deadrise

Re: deadrise

Re: deadrise

Re: deadrise

Re: deadrise