HI
I have a1994 370 express. Sometimes over 3000RPM's my starboard engine just cuts out, sometimes stalls and need to wait a bit till she starts up?
I rebuilt carb.
New complete distributer assemble coil module
new plugs,wires.
I have that mss somthing ignition, could it be that?
Thanks, Eric
crusader 454xl cuts out over 3000RPM sometimes
Moderators: BeaconMarineBob, Moderator, BeaconMarineDon
-
- Registered user
- Posts: 6
- Joined: Wed Feb 26, 2014 5:08 pm
Re: crusader 454xl cuts out over 3000RPM sometimes
Did you check fuel pump and or anti siphon valve? could be starving for fuel at that RPM
1984 Silverton 37C
Silver Lining
Scott
Silver Lining
Scott
Re: crusader 454xl cuts out over 3000RPM sometimes
Back to basics....Need to determine if it's an ignition or fuel issue so you know which system to focus on. Take a run, and when she quits again, you need to find out right away if you are at least getting a spark when you try to start her again. If you are getting a nice clean bright spark, it's likely a fuel related issue. If you don't get a spark, it's an ignition issue.
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
And thanks to the gang, 2012 Trojan Boater Of The Year
-
- Registered user
- Posts: 6
- Joined: Wed Feb 26, 2014 5:08 pm
Re: crusader 454xl cuts out over 3000RPM sometimes
Did you check fuel pump and or anti siphon valve? could be starving for fuel at that RPM[/quote]
THANK YOU
Where is the anti siphon valve,and what does it look like?
THANK YOU
Where is the anti siphon valve,and what does it look like?
-
- Registered user
- Posts: 6
- Joined: Wed Feb 26, 2014 5:08 pm
Re: crusader 454xl cuts out over 3000RPM sometimes
Turned out to be spark.
Swaped computer, same problem.
Swapped ignition relay, problem switched to port moter,
$34.00 problem solved
THANKS
Swaped computer, same problem.
Swapped ignition relay, problem switched to port moter,
$34.00 problem solved
THANKS
Re: crusader 454xl cuts out over 3000RPM sometimes
I had the pin in my manual fuel pump arm fall out. Engine ran fine at 2900 rpms. Past that she would stall out. Anti siphon valve is at the gas tank line to the carb. Hope this helps.