osco raisers and elbows gaskets

James Rigby · Post by **James Rigby** » Fri Mar 28, 2014 10:03 pm

Please tell me the proper gasket to install on my raisers and elbows.I have gaskets with 2 holes and one hole,need to know witch one go's on the raiser and witch one go's on the elbow.I have a Chrysler 318 fresh water cooled with raw water intake.Thanks James

James Rigby · Post by **James Rigby** » Fri Mar 28, 2014 10:10 pm

Need oil pump shaft and gear for a Chrysler 318 reverse rotation that connects to the distributor,any ideas where I can find one,it'sa 1976.Thanks James

prowlersfish · Post by **prowlersfish** » Sat Mar 29, 2014 6:58 am

James Rigby wrote:Please tell me the proper gasket to install on my raisers and elbows.I have gaskets with 2 holes and one hole,need to know witch one go's on the raiser and witch one go's on the elbow.I have a Chrysler 318 fresh water cooled with raw water intake.Thanks James

That would depend on whether your manifolds or maifolds and elbows are fresh water cooled or raw water cooled . 3 different ways I believe they have done it .

James Rigby · Post by **James Rigby** » Sat Mar 29, 2014 1:08 pm

salt water go's threw manafolds ,raisersand elbowws

prowlersfish · Post by **prowlersfish** » Sat Mar 29, 2014 3:36 pm

Then you use the ones with 2 holes

Big D · Post by **Big D** » Sat Mar 29, 2014 7:13 pm

Call Osco. Tell them exactly what you have. They are usually really helpful. Lots of info of their site too.
http://www.oscomotors.com/catalog/catalog22.asp

Trojan Boat Forum

osco raisers and elbows gaskets

osco raisers and elbows gaskets

Oil pump shaft and gear

Re: osco raisers and elbows gaskets

Re: osco raisers and elbows gaskets

Re: osco raisers and elbows gaskets

Re: osco raisers and elbows gaskets