Page 1 of 1
Ignition Control Module
Posted: Fri Apr 25, 2014 11:18 am
by Lawman
Hey Guys, I'm thinking of replacing the ignition control module on the starboard motor,( Mopar 318's) nothing wrong with the existing one. Had to replace one on port motor last year and was thinking of preventive maintenance by replacing it and keeping the existing one as a spare. My question is, if I put a new one in will it change timing or anything??
Re: Ignition Control Module
Posted: Fri Apr 25, 2014 12:47 pm
by ready123
Why not keep a new one as spare? Can't see the logic of an old one as spare, if it works keep using it if it doesn't trash it
Re: Ignition Control Module
Posted: Fri Apr 25, 2014 7:24 pm
by Big D
If it's specifically for a Mopar 318 marine app, it should be the same advance curve
Re: Ignition Control Module
Posted: Sat Apr 26, 2014 3:45 pm
by kallen
Don't forget 4 or 5 pin connector. Recommend changing the ballast resister to.
Re: Ignition Control Module
Posted: Sat Apr 26, 2014 5:02 pm
by prowlersfish
Big D wrote:If it's specifically for a Mopar 318 marine app, it should be the same advance curve
And that is assuming both old and new are marine