Trojan Boat Forum

Start by drying everything out. Make sure fresh water is disconnected, drain fresh water tank, water heater and waste tank. once it is dried look to see where it is coming from. If it hasn't rained it's likely shaft packing, rudder packing. But check every below waterline thru hull. If you still don...

The Express model didn't have a complete wall. It's on the port side only

Welcome.

My F-32 Express has the head directly in front of the lower helm. The V birth has a wall with closet to port and a hanging locker that goes just above the dinette. Other than that it is open.

Hi Rick

I didn't get any P.M. Happy new year

Rick, I spent the day at the new boat. I learned a lot about how it was assembled. My mechanic and I believe Carver took the best of Trojan and the best of Carver and made some really good and underappreciated boats. No wood below the water line including stringers like the 10 meter. I found that th...

Rick, First thank you for the response. And yes my name is Dustin. I have the 78 F-32 Express and I just got a 99 360 Express. Thanks again there isn't much info online about these models. The Carver support is weak.

I got some brackets from Beacon Marine then made the supports from teak.

Shane, Ask away. I own one of these boats. Rick Shane. I'm getting ready to rebed all of the deck hardware. Is there access to the bottom of the bow rail fittings? Is there a threaded backing plate or just nuts and washers? I have a 99 built by Carver so they may be different. I've looked around a ...

I have both the Trojan and Trojan by Carver. I'm keeping the F-32 because a wise man once said "Life is to short for an ugly boat"

Remove old F-32 from dock and replace with new to me 99 Trojan 360.

Just FYI. if the bushings are worn out in the distributor from being 42 years old the kit won't fix that. I would check the play and runout on the shaft before you buy just the kit.

I bought the complete Petronix distributor. Installation was easy. As stated above you will need to bypass the ballast and get the required coil. I ordered from Summitracing.com they had them in stock and are local for me.

Also do a voltage drop down test. Do it cold then when its warmed up, both engines and record your data

Try switching parts from port to starboard.