Holding tank

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
User avatar
gettaway
Active User
Posts: 1142
Joined: Mon Feb 15, 2010 1:48 pm
Location: Coronado CA

Holding tank

Post by gettaway »

Hi ,

I recently purchased a 1977 Trojan F-32, I have have spent the last 5 weeks cleaning the boat, I have stripped the interior teak and varnished everylast piece, I reupolstered the dinette seats, recovered the bulkhead along the dinette and in the forward cabin. The exterior teak has been sanded, cleaned and brightened and now has a gleaming 7 coats of Z-Spar varnish, this past weekend I did the dreaded task of replacing all of the holding tank hoses, all of them. I had filled the holding tank with fresh water and a half a bottle of Pine-Sol and it sat for about 3 weeks before I pumped it out before this job, which made the task a little more tolerable.

Anyways, my holding tank is in the bow of the boat in the peak below the bunks, is this the factory location? The macerator pump must pump waste from the head, up and over to the tank, a total of about a 10' run and up hill so it tacks a fair amount of flush water to make sure waste makes it to the tank, with this system, it would seem that for every "pee" it would take a bout a gallon of water to get it to the tank. (no poo allowed in the boat unless your dying and can't make it to the clubhouse)
It seems that the logical place should have been below the sole in the dinette galley area.


User avatar
ready123
Ultimate User
Posts: 1841
Joined: Sat Nov 08, 2008 5:53 pm
Location: Mactier, Ontario Canada
Contact:

Post by ready123 »

I believe that is the factory location. Mine was there... I removed it and went to a composting head and so need no water nor holding tank. My buddy moved his to under the galley sink.

Is your head a Vacu flush? If it were it would use much less water about a half liter per flush.
Where are you located? Why not add some info to your profile.

This might interest you...
http://www.flickr.com/photos/32233258@N ... 959868492/
Michael
Rum is the reason Pirate's have never ruled the world
Done Dreamin'
1987 President 43' Twin Lehman 225SP Turbo
Highfield 310 Ally 15 HP Yamaha 2cycle
1978 F32 Sedan twin 318 Chry SOLD
Safe Cove Marina, Port Charlotte, FL
User avatar
gettaway
Active User
Posts: 1142
Joined: Mon Feb 15, 2010 1:48 pm
Location: Coronado CA

Post by gettaway »

Thanks for the information,
I have not figured out to post a photo, this sight seems to make you jump though a lot of hoops for a simple photo.
Anyways,
I am located in San Diego CA and Keep the boat at the Coronado Yacht Club in Glorietta Bay, I bought the boat up in the Port of Long Beach, the previous owner appeared to have let her sit for quite some time so there was a fair amount of defered maintenance. That being said, I bought her for a song.
I did have the hull and machinery surveyed by two seperate surveyors, engines first, and it is a sound boat, howeve, she was dirty and full of stuff.
My wife and I have spent every weekend cleaning and it has really paid off, the boat is coming around and we enjoyed the 4th of July weekend on the boat.
Danny Bailey
Moderate User
Posts: 478
Joined: Thu Dec 29, 2005 10:44 pm
Location: Oriental, NC

Post by Danny Bailey »

Check this out. http://www.natureshead.com No more hoses. No more holding tank. No more pumpouts. No more stink.
1980 F-36 with 6BTA 250 Cummins enjoying the Sounds and coastal waters of North Carolina
Post Reply