Back to looking at 11 Meters

alexander38 · Post by **alexander38** » Sun Nov 28, 2010 10:56 am

do and search here on the site me and 3 other guys did it about the same time the part # should be in there, also you can go to jacks small engine parts (all one word).com and look for onan cck parts most of the air cooled stuff fits our mcck 6.5's he also can get water pumps ect.....

rpdwyer · Post by **rpdwyer** » Sun Nov 28, 2010 1:51 pm

Hi All.

Sorry... haven't been ignoring the posts... at least not intentionally. Didn't receive any notifications there were responses.

Well, I purchased a boat:

http://www.yachtworld.com/boats/1997/La ... ted-States

It is smaller than the 11 meter but the gas burn is very good and will make a good first boat for a family of 4.

I paid $15,500 for it with a 136 hours on the engines. I was just under the hood yesterday doing preventative maintenance... replacing water circulating pumps on both mercs, as well as hoses, belts and tensioners.

Dropped the starboard stern drive today and will be putting new water pumps in both drives this week.

Other than that, the boat is in excellent shape and very clean... especially the engine compartment.

The 11 meter is still the boat I want and hope to own someday. But for now, the Larson will be fine in the interim and gets me on the water in the spring.

Thanks all for the responses.
--Rick

alexander38 · Post by **alexander38** » Sun Nov 28, 2010 3:14 pm

Good luck with her.

RWS · Post by **RWS** » Sun Nov 28, 2010 5:05 pm

Nice boat.

Enjoy her and make all those moments with the family count.

It can all be over faster than you realize.

RWS

aaronbocknek · Post by **aaronbocknek** » Mon Nov 29, 2010 4:27 am

alexander38 wrote:do and search here on the site me and 3 other guys did it about the same time the part # should be in there, also you can go to jacks small engine parts (all one word).com and look for onan cck parts most of the air cooled stuff fits our mcck 6.5's he also can get water pumps ect.....

the direct link to the site is as follows.

http://www.jackssmallengines.com/onan_parts_index.cfm

prowlersfish · Post by **prowlersfish** » Mon Nov 29, 2010 6:55 am

Nice , good luck with it ,I belive this will be a good fit given the guide lines of your needs . Good Choice !!