Trojan Boat Forum

comodave,

Can you or anyone that has actually done this on an F-32 please post some pictures as to I can tell exactly where I should drill them on my boat? Or just give me the exact measurements maybe from say I don't know the V-birth door centerline of the boat?

sent you an email if you have any more left...

Thanks,

Adam

I'm 32 been around the water since a kid with the family boat at my grandfather's house, currently work at a steel mill in Indiana after working for a major engine manufacturer building diesel engines. After giving up my racing dream driving race cars for 15 years bought a 22 BR crownline and ran it...

Hi all, I'm looking at buying a new setup GPS/fishfinder for my F32. But what I really think I would be most interested in is the fuel flow information/data capabilities. Any ideas? I've been looking into the Garmin 541 and the Hummingbird 798 but I'm now sure how and if they are fully capable. Woul...

you guys wouldn't have any pictures of what you have drilled or cut out would you?

Hello everyone,

It is finally hot on lake Michigan and my A/C keeps tripping the breaker. Was wonder if anyone had any ideas on where to start trouble shooting? I was thinking maybe low on freon but not sure.

Thanks in advance,

Adam N.
East Chicago Marina

Does anyone know the cost of a replacement generator for an onan generator? I bought my F-32 without the generator because the generator engine blew and the guy just threw it out. I have a big empty space and was curious if it would be worth my while to get a new generator.

Thanks,

Adam

My 75' f32 has copper lines all the way to the carbs. Just moved and topped it off for the start of the season yesterday and noticed the filler lines were badly rusted at least on 1 of the 4. Kind of afraid to check the tanks. BTW, Hammond IN marina had gas cheaper than most all gas stations we pass...

I was able to replace both of my props with a 10" gear puller without having to remove the rudders...

Ok, after further review I found that the rubber hose was just a cover to help keep all the hiem joints holding grease and not get grease over everything else. Does anyone know what thread and pitch the heim that goes into the shaft is? I know it is fine pitch and it is not 5/8 or 16mm or 18 mm took...

Anyone out there update your electronics lately? I've got an old (91) Raymarine tower and old Garmin GPS with no fish finder. I was interested in an all in one but am not sure if I can update the radar with newer glass without replacing everything. Any suggestions would be great as I'm kind of lazy ...

I'm new to this message board and a new owner for my 1975 F32. I bought the boat last July and have the terrible smell I've read so much about. It is only in the v berth and I can disguise the smell by just closing the door. I've read several posts about the hollow keel being the problem, but I want...

Thank you all for your help, next time I get out to my boat I will post a photo. It's only 12 degrees today here so I'll go later on. If this is not a stock setup then I actually like the repair the way it is as the rubber hose actually acts as a buffer if you run aground and hit the rudders because...

I am only talking about the tie-rod in between both rudders, one is hooked up and the other is not. The heim/rod end (not helm) is what connects the tie rod to the rudder - but there is a piece of rubber hose inbetween the rod end and tie-rod. My boat is mechanical steering if that matters at all an...

I've got a 1975 32' flybridge with one rudder not hooked up to the linkage. The setup on my boat currently is rubber hose hooked to the heim and to the linkage bar that is torn. I was wondering if this is factory made or some easy fix to another problem by the previous owner. (I just bought the boat...