Trojan Boat Forum

I have had a 1981 F32 for 10 years and think its a great boat. I would check stringers and you did not mention engines that are the boat you are looking at. Also check gas tanks. I have the original tanks and no problems yet. Gd luck

When I open a faucet I have pressure, than it starts slowing up a lot--pump does not go on unless a faucet is turned on--this just started since I filled tank yesterday--was fine till than-- took strainers off --batteries new this season--will look for strainer--any other ideas

Ran out of water and just filled tank tonight---pump goes on when faucet is turned on, but after a short time pressure is not strong--when faucet is shut off pump will shut down in a short period--new jabsico pump last summer--if there was leak in system pump would just keep running--why is it not h...

Mel--that topside looks great--can you explain the replacement--what material used--did not see RPM gauges for each engine--what year is year is your Trojan--topside similar to mine which is a 81

Thanks

Looking for opinions--have an 81 f32 with dual stations-- original gauges--know that the gauges are not accurate--I think---do gauges wear out----would replacing senders help-- if new gauges are needed have to rewire all--or should i not look for problems--Thanks---boat on hard ground for winter

I would think each has to have its own fuel line. If both were on the same line and both running at the same time, I think one would not get enough fuel.

good Luck

its raw water cooled---disconnect hose and pump is working fine---only took one head off

Started a project on my 19981 gen set. I have had the carb rebuilt, 2 hew thermostats, all new hoses, gas pump, and impeller. Had to take intake head off since it was clogged and cleaned it out. Starts up fine, giving out plenty of juice, but very little water is being pumped out. Mechanic says its ...

Have 318 engines and replaced alternators 2 yrs ago--single wire. Notice the last few days one gauge is reading about 12 when started and barely goes to 13. It was reading past 13 after starting engine and giving it throttle. Also notice when turning ignition switch on barely gets out of red. Had th...

i was going to run my gen without the 2 thermostats and my mechanic says not to. I do not leave it running long at all--usually just to make coffee. Was going to replace then over the winter

Any thoughts

Thanks

I have a 1981 f32 and have to say I love it--Did have a small stringer issue in the aft and ended up having them "sister" on both sides and up the transom--- did have it surveyed last month for the insurance company and all passed very well--no major issues----but remember these are all ol...

I meant t o say it is the alarm that beeps when you turn on the ignition switch. It is working on one engine and not the other. They are 318 engines on a 1981 f32---what should I look for

Thanks

One of my 318s warning horn is not working when you flip the toggle switch horn. How do you repair?

Thanks

Just had my 1981 f32 surveyed for my insurance company. The only issue that was mentioned was the area on deck around the cleats. I checked the area and does not feel soft . Surveyor mentioned that there is some softness and could weaken the holding of cleats. Has anybody have the same problem? What...

I re-powered a couple of years back and only wished that I repainted the bilge at that time. I saw a picture of one that was painted. Not sure if you would be better off using an epoxy base paint, but I am sure there are people here that are more knowledgeable